Power Connector; Operating Requirements - XMOS xCORE-200 explorerKIT Hardware Manual

xCORE-200 explorerKIT Hardware Manual
Pin
X0D01
X0D04
X0D05
X0D06
X0D07
Figure 16:
QSPI Flash
X0D10
12 24MHz Crystal Oscillator
The xCORE-200 explorerKIT board is clocked at 24MHz by a crystal oscillator. Each
tile is clocked at 500 MIPS, and all I/O ports are 100MHz.

13 Power connector

xCORE-200 explorerKIT requires a 5V power source input via the micro-USB cable.
Figure 17:
Power
connection
via micro-USB
The voltage is converted by the on-board regulator to the 1V and 3V3 supplies
used by the components. Additional or alternative power sources may use the
power headers provided as shown in Figure 18:
Connector
Figure 18:
J14
Power
connectors
J15
See the Operating requirements section

14 Operating requirements

A USB 2.0 high-speed compliant cable of less than 3m in length should be used
when operating the xCORE-200 explorerKIT. XMOS cannot guarantee correct opera-
tion of the xCORE-200 explorerKIT should any other cable be used.
XM007647C
Port QSPI connection
P1A CE_n
P4B0 IO0
P4B1 IO1
P4B2 IO2
P4B3 IO3
P1C SPI_CLK
J16
Pin 1 Pin 2
+5V +3.3V
+5V +3.3V
Pin 3
GND
GND
§14 for further information.
10/18