Adjusting The Spring Preload Of The Shock Absorber - KTM Freeride E-XC 2021 Owner's Manual

12 TUNING THE CHASSIS
12.9
52

Adjusting the spring preload of the shock absorber

Caution
Risk of injury Parts of the shock absorber will move around if the shock absorber is detached incorrectly.
The shock absorber is filled with highly compressed nitrogen.
–
Please follow the description provided. (Your authorized KTM workshop will be glad to help.)
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the spring
length.
402659-10
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. ( p. 69)
–
Remove the Powerpack HV. (
–
Mount the protection cap. (
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
1
Loosen screw .
–
2
Turn adjusting ring until the spring is no longer under ten-
sion.
Hook wrench (90129051000)
Info
If the spring cannot be fully released, the spring must
be removed to accurately measure the spring length.
–
Measure the total spring length while the spring is not under
tension.
–
Tension the spring by turning adjusting ring
A
dimension .
Guideline
Spring preload
Info
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
1
Tighten screw .
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Remove the motorcycle from the lift stand. (
–
Install the Powerpack HV. (
p. 43)
p. 108)
p. 71)
p. 57)
( p. 68)
2
to specified
9 mm (0.35 in)
M5 5 Nm (3.7 lbf ft)
( p. 68)
p. 57)
p. 109)