Powerwall Stack Kit Contents; Required Tools - Tesla Powerwall 2 Installation Manual

Powerwall Stack Kit Contents

•
(2) Side clips
• (1) Top cover
• (1) Conduit nipple
• (2) Conduit insulation bushings
• (2) Conduit sealing O-rings
• (1) Bridge piece
•
(1) 5-conductor communication cable
•
(1) Wiring interface cover
•
(4) Magnetic camshaft caps
•
(1) 6 mm Allen wrench
• (1) Drill guide (two pieces)

Required Tools

• Personal protective equipment (safety glasses, gloves, protective footwear)
• Drill and 6 mm (1/4-inch) drill bit (for drilling pilot hole in Powerwall chassis)
• 35 mm (1-3/8 inch) hole saw (for drilling conduit hole in Powerwall chassis)
• Small metal file (for removing burrs from Powerwall chassis sheet metal)
• Rubber mallet or small hammer and wood block (for seating side clips in Powerwall)
•
Wire strippers/cutters for 1.5 to 8 mm
•
Small grease applicator (wooden craft stick or cotton swab)
•
Water-resistant heavy-duty grease (Dow Corning Molykote BR-2 Plus High
Performance Grease or equivalent, for preventing corrosion on side clips)
• Installation tools (level, tape measure, pencil, flashlight)
2
2 (24 to 8 AWG) wires
Powerwall Stack Kit Installation Manual