Technical Data - Indesit K1E107/RU Operating Instructions Manual

6. Close the terminal board cover by tightening the
GB
screws V.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the
load indicated on the data plate located on the
appliance.
The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
the appliance and the mains. The circuit-breaker
must be suitable for the charge indicated and must
comply with current electrical regulations (the
earthing wire must not be interrupted by the circuit-
breaker). The supply cable must be positioned so
that it does not come into contact with temperatures
higher than 50°C at any point.
Before connecting the appliance to the power
supply, make sure that:
• The appliance is earthed and the plug is compliant
with the law.
• The socket can withstand the maximum power of
the appliance, which is indicated by the data
plate.
• The voltage is in the range between the values
indicated on the data plate.
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only.
! The manufacturer declines any liability should
these safety measures not be observed.
*
Only available in certain models.
14

TECHNICAL DATA

Oven dimensions
38x34x39 cm
(WxDxH)
50 l
Volume
Useful
width 42 cm
measurements
depth 44 cm
relating to the oven
height 18 cm
compartment
Power supply
see data plate
voltage and
frequency
Electric hob
600 W
Front left
2000 W
Back left
1500 W
Back right
Front right 1500 W
Maximum absorption
of the electric hob
5600 W
Directive 2002/40/EC on the
label of electric ovens. Standard
EN 50304
ENERGY LABEL
Declared energy consumption
for Natural convection Class –
heating mode:
EC Directives: 2006/95/EC
dated 12/12/06 (Low Voltage)
and subsequent amendments -
2004/108/EC dated 15/12/04
(Electromagnetic Compatibility)
and subsequent amendments -
93/68/EEC dated 22/07/93 and
subsequent amendments -
2002/96/EC.
1275/2008 (Stand-by/ Off mode)
a
Static