Installation; Mounting - Eagle IntelliMap Journey Installation And Operation Instructions Manual

Thank you for purchasing an Eagle product! You won't find another com-
bination GPS and sonar unit with these features and power for the money!
Each of our products is designed and manufactured to precision toler-
ances for long life under extreme conditions. We hope that you'll enjoy this
product for years.
This manual covers both the Eagle Status™ and Journey™. Both are 12-
channel GPS receivers, however the Status™ also has a sonar built into
the unit. The installation of these two products vary, otherwise the GPS
operation of the two units is nearly identical.
No matter which unit you own, please read the installation section care-
fully, especially the transducer section. Many times future trouble can be
avoided by carefully locating and wiring the equipment.
If you do have problems, please read the troubleshooting section in the
back of this manual. You may find the solution to your problem there. The
Eagle customer service department also has representatives available to
answer your questions on our toll-free telephone lines. See the back page
of this manual for more information.
We want your experience with our equipment to be a happy one. Good
luck, and good fishing.

INSTALLATION

Mounting - All Units
Install the unit in any convenient location, provided there is clearance
behind it when it is tilted for the best viewing angle. Holes in the bracket
base allow wood screw or through-bolt mounting. You may need to place
a piece of plywood on the back of thin fiberglass panels to secure the
mounting hardware. Make certain there is enough room behind the unit to
attach the power and transducer cables.
The gimbal bracket will also accept the GBSA-1 swivel bracket adapter
that lets you rotate the unit a full 360°.
The smallest hole that allows one power or transducer connector to pass
through is 3/4".
1