Additional Information; Precautions - Sony MZ-DH10P Operating Instructions Manual

Additional Information

Precautions

On safety
• Do not put any foreign objects in the DC IN
6V jack.
• Do not touch the optical pickup lens on the
player and keep it clean. If you do so, the
lens may be damaged and the player will
not operate properly.
On power sources
• Use house current or rechargeable battery.
• For use in your house: For the supplied USB
cradle, use the AC power adaptor supplied
with this player. Do not use any other AC
power adaptor since it may cause the player
to malfunction.
• Connect the AC power adaptor to an
easily accessible AC outlet. Should you
notice an abnormality in the AC power
adaptor, disconnect it from the AC outlet
immediately.
• The player is not disconnected from the
AC power source (mains) as long as it is
connected to the wall outlet, even if the
player itself has been turned off.
• If you are not going to use this player for a
long time, be sure to disconnect the power
supply (AC power adaptor or rechargeable
battery). To remove the AC power adaptor
from the wall outlet, grasp the adaptor plug
itself; never pull the cord.
60
On the player
• Do not shake or strike the player. In addition
to malfunctions and inability to record
images, this may render the disc unusable or
image data breakdown, damage or loss may
occur.
• Do not get the player wet. When taking
pictures outdoors in the rain or under
similar conditions, be careful not to get the
player wet.
• Your player is designed for use between
the temperatures of 0°C and 40°C (32°F
and 104°F). Shooting in extremely cold
or hot places that exceed this range is not
recommended.
• After using your player at the seashore or
other dusty locations Clean your player
carefully. Otherwise, the salty air may
corrode the metal fittings or dust may
enter the inside of your player, causing a
malfunction.
On heat build-up
Heat may build up in the player if it is used
for an extended period of time. This, however,
is not a malfunction.
On mechanical noise
The player gives off mechanical noise while
operating, which is caused by the power-
saving system of the player and it is not a
problem.
On installation
• If you use the player at a place subject to
static or electrical noise, the recording may
not be properly done or the recorded data
may be lost.
• Never use the player where it will be
subjected to extremes of light, temperature,
moisture or vibration.
• Never wrap the player in anything when it
is being used with the AC power adaptor.
Heat build-up in the player may cause
malfunction or damage.