Adjustment Procedures; Repair Procedures; Return To Service Procedures - Honeywell HS-700 Description And Installation Manual

SYSTEM DESCRIPTION AND INSTALLATION MANUAL
(2) Reinstall the HSU.
(a) Remove the HSU from the protective carrying case and protective
static--resistant bag.
(b) Remove the electrostatic protective covers from the HSU rear connector.
(c) Install the CDM. Refer to paragraph 3. in this section.
(d) Slide the unit into the mounting tray.
CAUTION: WHEN PLACING THE UNIT ON THE MOUNTING TRAY, DO NOT
FORCE FIT. IF MATING IS DIFFICULT, REMOVE THE UNIT AND
CHECK FOR CONNECTOR PINS THAT CAN BE BENT OR OUT OF
ALIGNMENT. ALSO VISUALLY CHECK THE ALIGNMENT OF THE
RECEPTACLE ON THE MOUNTING TRAY.
(e) Gently slide the unit backwards until its connectors are fully engaged with the
mating connectors of the mounting tray.
(f) Put the holddown clamps in place and tighten the knobs in a clockwise direction
until the proper torque is applied (clutch engages).
(g) Reapply power to the HSU and its interfacing equipment.
NOTE: Upon applying primary power, the HSU will automatically power up and
start a POST.
B. Adjustment Procedures
(1) Not applicable.
C. Repair Procedures
(1) Not applicable.
D. Return to Service Procedures
(1) Refer to test procedures in the INSTALLATION CHECK section of this manual.
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
HS--700 High Speed Data System
23- -20- -33
Page 7--2
30 Aug 2002