Table of Contents
Advertisement
362
6-1. Maintenance and care
WARNING
Precaution regarding the rear
■
bumper with Blind Spot Monitor (if
equipped)
If the paint of the rear bumper is chipped
or scratched, the system may malfunc-
tion. If this occurs, consult your Lexus
dealer.
NOTICE
To prevent paint deterioration and
■
corrosion on the body and compo-
nents (aluminum wheels, etc.)
●
Wash the vehicle immediately in the
following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the
paint surface
• If dead insects, insect droppings or
bird droppings are present on the
paint surface
• After driving in an area contaminated
with soot, oily smoke, mine dust, iron
powder or chemical substances
• If the vehicle becomes heavily soiled
with dust or mud
• If liquids such as benzene and gasoline
are spilled on the paint surface
If the paint is chipped or scratched,
●
have it repaired immediately.
●
To prevent the wheels from corroding,
remove any dirt and store in a place
with low humidity when storing the
wheels.
■
Cleaning the exterior lights
Wash carefully. Do not use organic
●
substances or scrub with a hard brush.
This may damage the surfaces of the
lights.
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
●
Do not apply wax to the surfaces of the
lights.
Wax may cause damage to the lenses.
■
To prevent damage to the windshield
wiper arms
When lifting the wiper arms away from
the windshield, pull the driver side wiper
arm upward first, and repeat for the pas-
senger side. When returning the wipers
to their original position, do so from the
passenger side first.
When using an automatic car wash
■
(vehicles with rain-sensing windshield
wipers)
Set the wiper switch to the off position.
If the wiper switch is in "AUTO", the wip-
ers may operate and the wiper blades
may be damaged.
When using a high pressure car wash
■
●
When washing the vehicle, do not let
water of the high pressure washer hit
directly or the vicinity of the camera.
Due to the shock from the high pres-
sure water, it is possible the device may
not operate as normal.
Do not bring the nozzle tip close to
●
boots (rubber or resin manufactured
cover), or connectors or the following
parts.
The parts may be damages if they
come into contact with high-pressure
water.
• Traction related parts
• Steering parts
• Suspension parts
• Brake parts
●
Keep the cleaning nozzle at least 30
cm (11.9 in.) away from the vehicle
body. Otherwise resin section, such as
moldings and bumpers, may be
deformed and damaged. Also, do not
continuously hold the nozzle in the
same place.
Advertisement
Table of Contents
