264
4-5. Using the driving support systems
Vehicle-to-vehicle distance set-
tings (vehicle-to-vehicle dis-
tance control mode)
Select a distance from the table below.
Note that the distances shown corre-
spond to a vehicle speed of 80 km/h
(50 mph). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed.
Distance options
Long
Medium
Short
Canceling and resuming the
speed control
1
Pulling the lever toward you can-
cels the speed control.
The speed control is also canceled when
the brake pedal is depressed.
2
Pushing the lever up resumes the
cruise control and returns vehicle
speed to the set speed.
LEXUS NX300/NX200 Owners Manual̲General̲M78540̲en
However, cruise control does not resume
when the vehicle speed is approximately
25 km/h (16 mph) or less.
When your vehicle is too close to a
vehicle ahead, and sufficient automatic
deceleration via the cruise control is
not possible, the display will flash and
the buzzer will sound to alert the driver.
Vehicle-to-vehicle
distance
An example of this would be if another
driver cuts in front of you while you are
Approximately 50
following a vehicle. Depress the brake
m (160 ft.)
pedal to ensure an appropriate vehi-
Approximately 40
cle-to-vehicle distance.
m (130 ft.)
Approximately 30
m (100 ft.)
■
In the following instances, warnings
may not occur even when the vehicle-
to-vehicle distance is small.
When the speed of the preceding
When the preceding vehicle is trav-
Immediately after the cruise control
When depressing the accelerator
Approach warning (vehicle-to-
vehicle distance control mode)
Warnings may not occur when
vehicle matches or exceeds your
vehicle speed
eling at an extremely slow speed
speed was set