Jacuzzi J-400 Series Installation Manual And Use & Maintenance page 69

Cleaning the Filter Cartridges
Reminder
It's time to clean or replace
your ProClarity and Pro-
Clear filters. Contact your
authorized dealer if new
filters are needed.
reset snooze
A reminder message appears on the control panel display after a
specified number days to remind you to clean the skimmer filter
and to check the polishing bag filter.
This reminder must be reset at each filter cleaning interval.
Refer to Section "Water Care Programming" for additional informa-
tion and programming details.
Your new spa is equipped with an advanced 2-Stage filtration
system.
- Fine debris are filtered by the circulation pump drawing water
through the ProClarity™/ProClear™ skimmer and pleated filter car-
tridges.
- Large debris are filtered when jets pump 1 is running when the
spa is in use or during a programmed filter cycle. These pumps
draw water from footwell suction fitting and through a secondary
water polishing bag filter and additional filter.
Cleaning the filters and filter bag
To ensure optimum performance:
The ProClarity™ filter cartridge (A) must be cleaned every month
and replaced every 18 months.
The ProClarity Depth filter (B) must be replaced every 3 months.
The ProClarity filter canister (C) can be rinsed when the filters are
cleaned.
The filter cartridge for the ProClear II skimmer (D) must be cleaned
monthly and replaced every 18 months.
The ProClarity debris bag (E) should be checked and emptied
monthly.
To accomplish this, refer to the following filter cleaning procedure.
Note: Do not attempt to wash the ProClarity depth filter (B) and the
ProClear/ProClarity debris bag (E) or it will come apart!
A
P-r
B
C
P-r: Recirculation pump
P-hy: Hydro pump
Do not start the hot tub if the cartridges and filters have not been
installed correctly or if the cover is damaged.
E
D
Replacement filter cartridges may be purchased from your
authorized Jacuzzi dealer.
A. Turn power to spa off!
B
B. Lift the cover upward to access filter cartridges.
C. Remove the ProClarity debris bag from clips and then clean
out debris.
D. Rotate each filter cartridge handle counterclockwise to
unthread from mating wall fitting.
E
E. Lift unthreaded filter cartridge from skimmer well.
F. Rinse debris from filter pleats using a garden hose and
high-pressure nozzle.
P-hy
Start at the top and work downward towards handle.
Repeat until all pleats are clean.
G. Remove the filter pin (1) in order to separate the ProClarity filter
and canister.
1
2
3
H
69
C
D
1
F G
1
J
I