Table of Contents
Advertisement
8 Closing the housing
1
Place the Hugyfot Vision Xs
1
housing on a flat stable surface
with the monitor (with installed
sun hood) faced down.
2
Your housing has two o rings.
Carefully inspect, service
and lubricate each o ring
before diving.
3
Align and push the front shell
onto the back shell.
4
Close both latches.
2
Hugyfot User Manual Vision XS For GoPro Hero 9/10
3
10
Your Hugyfot Vision Xs GoPro housing
on.
comes with the Hugy-Check Xs system. This
pre-dive vacuum system consists of
Wait for at least 10 minutes and check if the
2 parts, a valve and a body.
green LED is still blinking. We recommend
•
The smaller part on top of the front
to prepare your housing and use the
shell contains a one-way valve and is
Hugycheck Xs vacuum system
sealed with a cap. We call this part the
2 hours prior to the dive.
valve.
•
The bigger part on top of the monitor
Blinking green LED indicates no pressure
shell contains 2 stacked LR44 batteries,
leak and safe to dive. Always verify if the
the HugyCheck electronics, both green
green LED is still blinking before entering
and red signaling LEDʼs and the vacuum
the water and before rinsing your housing.
release system. We call this part
the body.
To open the housing you will have to release
the vacuum first.
1
For first time use you will need to
To release the vacuum turn the body part
remove the transport sticker from the 2
counter-clock wards until you hear an air
stacked LR44 batteries in the body part.
sucking sound.
The LR44 batteries need to be installed
Both green and red LEDs are turned off and
each with the positive side first. For
your Hugycheck Xs vacuum system is now
your convenience they are delivered
turned off.
shrink wrapped together.
2
Turn on the Hugycheck Xs vacuum
For long time storage or transport we
system by screwing the body part
recommend to remove the LR44 batteries
completely till the end. Do not apply
(or put the transport sticker back on the
excessive force, this will not improve
batteries).
the sealing. You will see now the red
LED which is slowly blinking.
3
Remove the cap from the valve part and
install the vacuum pump.
4
Pump until the red LED changes to
green and continue pumping 3 strokes
more.
5
Seal the valve by screwing the cap back
11
9 HugyCheck Xs vacuum system
1
2
3
4
5
Hugyfot User Manual Vision XS For GoPro Hero 9/10
Advertisement
Table of Contents
