Advertisement
ⅠFuture and use
Magnetic drill can be adsorbed on the steel parts of the plane, side, top, surfaces. It widely used in
construction, bridge, boiler, shipbuilding and other industries. Some electric drills can not drill
inconvenient on large iron and steel part, you can use the magnetic drill, which is convenient,
flexible, and also can reduce labor intensity and improve machining accurately and efficient.
Because it has a unique role that can drill large hole (45 # steel can be drilled largest hole Φ80mm),
so it can be instead of some radial drilling machine.
Ⅱ Preparation before use
1. Insert the handle lever into the handle seat hole and next tighten them.
2. Turn the handle lever, check the guide board whether move freely.
3. Connect power and open magnet drill switch, you can see indicator lighting, which show
magnetic drill is in working condition. Use a screwdriver or iron bar in the bottom of magnet to
check whether have suction. Open the drill control switch, check the drill whether working.
Note: When moving magnetic drill, do not drag it on the ground in order to prevent magnet
damage.
ⅢSeveral working methods and precaution
1. Level work:
a. Move the magnet drill on the work surface (Note: magnet contact surface should be clean and
smooth, do not have iron debris)
b. Connect power and open magnetic control switch, so magnet firmly attach on the work place.
c. Install required drill, loosen the dial and tighten the top screws, turn the rack, so that the drill
can align the holes and tighten the top screw. Rotate supporting bar.
d. Open the drill control switch, so the drilling process. (Note: The feed is generally 0.55mm / r, so
not too much force in order to prevent overload)
e. When processing complete, turn off the control switch and magnet control switch and pick up
magnetic drill from work surface.
2. Side work: (Note: It needs two or more people operations, and some people care)
a. Insert the plug into power outlet.
b. Lift the magnet drill and make the magnet attached the work surface, open magnet control
switch, so magnet sucked the work surface firmly.
c. Fasten safety rope in order to prevent magnetic drill sudden drop .
d. Install required drill, loosen the dial and tighten the top screws, turn the rack, so that the drill
can align the holes and tighten the top screw. Rotate supporting bar.
e. Open the drill control switch, so the drilling process. (Note: The feed is generally 0.55mm / r ,so
not too much force, to prevent overload; When operation, people do not stand under the magnet
drill in order to prevent a sudden drop wounding people.)
f. When processing complete, turn off the control switch and magnet control switch and pick up
magnetic drill from work surface.
2
Advertisement
