Figure 8.
3.6
Spare Parts
The following parts are included in the spare parts kit.
Table 3:
Description
O-ring, face
Desiccant, sealed bag
Lubricant, silicone, 5.3 oz, Dow-Corning
Fuse, 3.0 Amp, 250V
4
WorkHorse Care
This section contains a list of items you should be aware of every time you
handle, use, or deploy your WorkHorse. Please refer to this list often.
4.1
General Handling Guidelines
P/N 957-6169-00 (April 2005)
Memory Card Overview
Spare Parts
• Never set the transducer on a hard or rough surface. The
urethane faces may be damaged.
• Always remove the retaining strap on the end-cap underwa-
ter-connect cable and dummy plug when disconnecting them.
Failure to do so will break the retainer strap.
• Do not apply any upward force on the end-cap connector as
the I/O cable is being disconnected. Stressing the end-cap
connector may cause the ADCP to flood. Read the
tenance guide
for details on disconnecting the I/O cable.
• Do not expose the transducer faces to prolonged sunlight.
The urethane faces may develop cracks. Cover the trans-
WorkHorse Mariner ADCP User's Guide
Part number
2-260
DES3
DC-111
GMA-3A
Main-
page 11