CP341
•
Click "Add". You will see a list of adapters.
•
Do not select an adapter from the list. Instead, insert your PEP Modular Computers
"Drivers" disk into your floppy drive and click "Have disk".
•
Type A:\ (or B:\) in the dialog box and click "OK". Then follow the interactive instruc-
tions to install the drivers. When the CP341 board is added, you will see its name
listed in the "Network adapters" list.
•
Select the CP341 interface board and click "Properties" to run PROSet to view the
board configuration or test diagnosis. Board diagnostics are available only while the
drivers are not loaded, i.e. before restarting your computer. Driver diagnostics are
available when the drivers are loaded.
3.2.3
Configuration Utility PROSET
PROSet is an enhanced utility you can use to easily configure and test your CP341
board in Windows NT. PROSet also displays the computer's resources that were
assigned to each CP341 interface board installed.
Figure 3-1: PROSet "Main Window"
To use the utility please procede as follows:
•
Click "OK" on the main PROSet window to return to Windows NT.
•
The CP341 board now appears on the list in the "Network" window. Click "Close" to
finish. Remove the Drivers disk from your system floppy drive.
•
Restart Windows NT when prompted.
•
To install multiple interface boards, repeat this procedure for each new adapter.
Page 3 - 6
® PEP Modular Computers GmbH
Installation
ID 18845, Rev. 0102