Specifications - PEP Modular Computers CP341 Manual

CP341

1.6 Specifications

Table 1-1: CP341 Specifications
Windows NT Compatibility
Ethernet IEEE Standard
Compact PCI Interface
Signalling Voltage
Plug & Play Design
Remote Boot
Speed Configuration
Wake-up on LAN (Remote
Wake-up)
Front-Panel Connector
Mechanical Compliance
Power Supply
Temperature Range
- Operation
- Storage
Operating Humidity
Vibrations
Shocks:
- Permanent Shocks
- Single Shocks
Board Dimensions
Page 1 - 10
CP341
Hardware design for WinNT network interface chip driver
(NIC) according to Windows and WinNT network driver
interface specification (NDIS)
10 Mbit/s 802.3 and 100 Mbit/s 802.3u
Peripheral board interface;
32-bit bus address/data/33 MHz
INT A/INT B support;
IDSEL hardware support;
CPCI data burst rate close to 132 MByte/s
1 4TE slot
3.3V/5 V
No jumpers to be configurated
2 x EEPROM/FLASH socket, 64 kByte max. each
Auto-speed sensing/switching
Package detection logics reacting on incoming packages
2 x RJ-45, with 2-pair 5 UTP/STP cable pinout each
IEEE 1101.10
3.3V/5 V, codes according to CPCI specification
• 0° to +60°C (standard)
• -55° to +85°C
5 - 95% (non-condensing)
IEC68-2-6 compliant
IEC68-2-29
IEC68-2-27
Single-height Eurocard: 100 mm x 160 mm
® PEP Modular Computers GmbH
Introduction
Specification
ID 18845, Rev. 0102