Table of Contents
Advertisement
CP341
3. Installation
As a sophisticated electronic device using AC power, your CP341 must be set up and
used correctly to maintain safe and proper functioning. Please follow the instructions in
this chapter fully to ensure successful installation and long lasting, trouble-free opera-
tion.
3.1 Hardware Installation
3.1.1
Cable Connections
To ensure correct operation of your network, you must use cables of permitted types
and lengths with your CP341, since some cable types are subject to mandatory limita-
tions in this regard. Cable categories are governed by the relevant EIA (Electronic
Industries Association) standards.
CP341 is designed to support star topology 2-pair Category 5 UTP/STP cables.
3.1.2
Board Placement
In deciding on a location for the unit which will house your CP341, the following factors
must be considered:
•
length of each cable connection between devices;
•
environmental factors.
Distance between Devices
If your network connections consist of twisted-pair connections, the maximum distance
between devices is 100 meters (328 feet). Using this cable type, the maximum length of
cabling between any two end nodes, including any uplink connection, is 205 meters.
These limits include every bit of cabling between the CP341 and other devices, both
inside and outside walls and wiring closets.
Environmental Factors
Your CP341 must be operated within specific environmental limits. It must not be
exposed to direct sunlight, strong magnetic fields, extremely dusty or humid air, extreme
heat or cold, or temperature shocks. For detailed guidance on these operating condi-
tions, please consult table 2-1 of this manual.
$
$
Important!
Mount your CP341 only after having ensured that the tower you
intend to fit it into is placed in a suitable location.
ID 18845, Rev. 0102
® PEP Modular Computers GmbH
Installation
Page 3 - 3
Advertisement
Chapters
Table of Contents
