Zanussi ZEN6641XBA User Manual page 12

Problem
The hob deactivates.
Residual heat indicator does not
come on.
Automatic Heat Up function does
not operate.
You cannot activate the outer
ring.
There is a dark area on the
multiple zone.
The heat setting changes be-
tween two levels.
The sensor fields become hot.
comes on.
comes on.
comes on.
12
Possible cause
You put something on the sensor
field .
The zone is not hot because it
operated only for a short time.
The zone is hot.
The highest heat setting is set.
You decreased the heat setting
to .
It is normal that there is a dark
area on the multiple zone.
Power management function op-
erates.
The cookware is too large or you
put it too near to the controls.
Automatic Switch Off operates.
The Child Safety Device or the
Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the
zone.
Remedy
Remove the object from the sen-
sor field.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Let the zone become sufficiently
cool.
The highest heat setting has the
same power as the function.
Start from and only increase
the heat setting.
Activate the inner ring first.
Refer to "Daily use" chapter.
Put large cookware on the rear
zones if possible.
Deactivate the hob and activate it
again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips" chapter.
Use cookware with correct di-
mensions.
Refer to "Technical information"
chapter.
www.zanussi.com