Vaniman STONEVAC II PLUS Instructions

120v

Advertisement

PACKING LIST

1 - StoneVac II Plus
1 - 2½" x 6' Hose
1 - Dust Bin Bag
1 - Elastic Retaining Band
1 - Power Cord
IMPORTANT SERVICE INFORMATION:
SAVE SHIPPING BOX AND FOAM FOR FUTURE
SERVICE. SHIPPING WITHOUT PROPER FOAM
MAY CAUSE DAMAGE TO UNIT
INSTRUCTIONS
1. Remove the unit and other parts from the box; check against the packing list. Remove the hose from
inside the dust bin as well as any protective paper packing material.
2. Plug the removable power cord into the back of the unit. Try the unit by pushing the switch to the ON
position making sure the AutoPilot AUTO/MANUAL switch is in the MANUAL position.
3. The vacuum hose supplied slips onto the vacuum connection near the front panel of the unit and the
other end connects to the collection device desired. The ideal location for the StoneVac II is under the
bench where the user works. The single station hose supplied is 2½" x 6 feet long and accordions to
the desired length. Hose extensions and adaptors are available from your dealer. We recommend,
however, that you try to keep the total length of hose less than 6 feet between the StoneVac II and the
dust collection point. Longer hose will reduce suction. See the enclosed accessories guide for collection
device details or call your Vaniman dealer.

CONNECTING THE AUTOPILOT

Introduction:
The AutoPilot allows you to control your dust collector from a micromotor or lathe. When
you start your micromotor, the dust collector will start automatically. When you stop your
micromotor, the dust collector will continue for a short period of time to allow for the residual
dust to be cleared.
1. Turn the unit on at the main power switch. Move the other switch to AUTOMATIC, the dust collector
should turn off.
25799 Jefferson Ave.
Murrieta, CA 92562
WARNING:
The Autopilot will accommodate a micromotor,
electric handpiece, or lathe that does not exceed
5 amps, 115VAC, total
1-800-VANIMAN (826-4626)
STONEVAC II PLUS
www.vaniman.com
sales@vaniman.com
STONEVAC II PLUS - 08/21 Page 1
120V

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STONEVAC II PLUS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vaniman STONEVAC II PLUS

  • Page 1 1. Turn the unit on at the main power switch. Move the other switch to AUTOMATIC, the dust collector should turn off. www.vaniman.com sales@vaniman.com 25799 Jefferson Ave. Murrieta, CA 92562 1-800-VANIMAN (826-4626)     STONEVAC II PLUS - 08/21 Page 1...
  • Page 2 Dust Bin ledge and gather the sides of the plastic bag together. Re- place the bag with a Vaniman replacement and place the bag into the Dust Bin, folding the open end of the bag over the Dust Bin edges, and putting the retaining band around the bag edges as before.
  • Page 3 If the circuit breaker was activated, push the button in the center to reset it. If the unit still does not operate, contact your dealer or call the factory at 1-800-VANIMAN for technical assistance.
  • Page 4 120V REPLACEMENT PARTS The following items are offered to enhance the usage of your quality Vaniman unit. These items can be order through your supplier using the following part numbers. Please feel free to contact Vaniman Mfg. Co. with questions regarding our products.

Table of Contents