Vaniman ABRASIVE VAC Manual

PACKING LIST
1 - AbrasiveVac unit
1 - Power Cord
1 - Foot Remote
1 - Pre-Filter/Accumulator
1 - 2½"x 3' Hose with 1½" Hose End
1 - 2½"x 6' Hose with 1½" Hose End
IMPORTANT SERVICE INFORMATION:
SAVE SHIPPING BOX AND FOAM FOR FUTURE
SERVICE. SHIPPING WITHOUT PROPER FOAM
MAY CAUSE DAMAGE TO UNIT
ASSEMBLY INSTRUCTIONS
1. Remove the unit and all additional parts from the two boxes. Check against the packing list.
2. Mount the Accumulator angle bracket on the side of the vacuum unit as shown by using the two
screws provided. Assemble the Accumulator to the bracket with the circular clamp provided. Rotate
the Accumulator to best route the hose then tighten the clamp.
3. Assemble the three foot hose, with the 1½" hose end, to the vacuum unit and the other end to the
top of the Accumulator. Gently rotate and push the hose end into the black foam gasket. If the hose
has difficulty connecting to the Accumulator, moisten the foam gasket with a small amount of water;
the water will help ease the hose into place. Connect the other hose from the side of the Accumula-
tor to the abrasive blaster. Use the grey hose end to connect to the Vaniman Sandstorm series or
ports of 1½ For 2½" hose connections, remove the grey hose end and use the remaining white
".
hose connector.
4. Plug the removable power cord into the socket on the top of the AbrasiveVac then plug the other
end into a standard 110 Volt wall socket. Connect the black remote switch tube to the black remote
switch connector on the unit; test by turning the power switch on or by pressing the remote switch.
140 N. Brandon P.O. Box 74, Fallbrook, CA 92028

1-800-VANIMAN (826-4626)

ABRASIVE VAC
120V
www.vaniman.com sales@vaniman.com
 
ABRASIVEVAC-I-08/15 Page 1