mabe RMF0411YINB0 User Manual page 26

8
before plugging in you must
Check that you have a socket which is compatible with the plug supplied
with the Fridge. If not see the section called electrical indormation on
page 13.
before switching on!
Do not switch on until four hours after moving the fridge.
The coolant uid needs time to settle. If the appliance is switched o at any
time, wait 30 minutes before switching back on to allow the coolant uid to
settle.
before lling your fridge
Before storing foods in your Fridge, turn the Fridge on and wait for 24
hours, to make sure it is working properly and to allow the Fridge to fail to
the correct temperature.
start
testing
1. Clean the parts of the refrigerator with lukewarm water containing a
little neutral detergent and with clear water, and wipe them dry.
note : Electric parts of the refrigerator can only be wiped by dry cloth.
Turn the thermostat knob to the "3" position, turn on electricity. The
2.
compressor and the light inside the refrigerator begin to work.
3.
Open the door 30 minutes later, if the temperature in the refrigerator
decreased obviously, it shows that the refrigerator system works well.
When the refrigerator operates for a period of time, the temperature
controller will automatically set the temperature within limits it opens.
temperature control
1. The temperature in the refrigerator compartment is controlled by the
temperature controller installed on the side wall of the refrigerator
compartment.
2.
Turn the thermostat knob to right or left, you can regulate the tempera-
ture inside the refrigerator.
3.
The marks on the knob are the temperature grades, not the exact
number of the degrees of temperature."0" shows a forced STOP and "7"
shows the lowest temperature. Turn the knob from "1"position to
"7"position, the temperature decreases continuously. You may set the
temperature control selector to any position according to what you
need.