Tone Generator - Klein Tools VDV Commander VDV501-097 Quick Start Manual

Tone Generator

Tone generation is used to trace cable runs and locate faults by sound.
This mode emits a cadence from the VDV Commander through the
connected cable. The tone is detected by a tone tracing probe*.
• Press the "On/Off" button
• Use the left and right arrow buttons
• The VDV Commander will automatically activate the tone
• Connect your cable to either the RJ45 jack or coax
• To switch between network and coax cables, press the
• Use the up and down arrow buttons
• Use the left and right arrow buttons
• Use a tone tracing probe* (PROBEplus VDV500-060) alongside
1.800.561.8187
* Probe is included in some kits.
GENERAL TESTING PROCEDURES
VDV Commander.
tone generator icon
generator upon entering the tone generator menu.
connector located on the top of the VDV Commander.
coax cable / RJ45 function button
tone cadences 1 through 4.
pin or pair to place the tone.
the cable or at the end of the cable to hear an audible tone.
www.
to power on the
to select the
and press the "Enter" button
/
to select which
information@itm.com
.com
.
.
to select