Klein Tools VDV Commander VDV501-097 Quick Start Manual page 4

Performing a Cable Test
Press the "On/Off" button
VDV Commander.
• Connect a network, coax, or telephone cable to the
• Press the "Enter" button
• To scroll through Cable Type mode, press the RJ45
• If a Test-n-Map
• If a remote is being used, connect the remote to the opposite
• To calibrate the VoP, connect a known length of cable to the
• While adjusting the VoP, press the test button until the desired
• To save the calibrated VoP, enter the settings menu and press
• Press the green test button
1.800.561.8187
GENERAL TESTING PROCEDURES
appropriate connector on the top of the VDV Commander.
WARNING: Do NOT plug an RJ12 cable directly into the VDV
Commander. A standard RJ12 cable will damage the VDV
Commander's RJ45 jack. Use the RJ adapter patch cable
(VDV726-125) that is included with the VDV Commander.
menu. The VDV Commander will automatically perform a
test upon entering the cable test menu.
function button. The icon will change with each press, from
RJ45 to coax to telephone
TM
remote is NOT being used (a one ended
test), the VDV Commander will test the length of each pair,
open, short, or split pair. Performing a one ended test will not
verify connectivity on the opposite end of the cable.
end of the cable.
VDV Commander and press the up/down/left/right buttons to
increase or decrease the VoP. Press the left and right buttons
to select and change the VoP one digit at a time.
length of the cable is displayed.
"Save" function button
the
NOTE: your adjusted VoP will be displayed next to the
RJ45 or coax icon.
function button
www.
to power on the
to display the cable test
/
.
or the loop mode
to perform additional tests.
.com
/ .
information@itm.com