Advertisement
GENERATOR SIZING
Below is the Engine-Generator Watt rating required to
power this pump motor. Any additional loads, such as lights,
must be added to the listed load and the generator sized ac-
cordingly.
Pump
Motor HP
1/3
1/2
UL Listed
Analyzer
Figure 3A
Outlet
Box
Figure 3B
No. 4
Wire
Figure 3C
Minimum Watt
Rating of Generator
2,200
2,800
Outlet
665 0194
Bare copper wire to
cold water pipe.
669 0194
Clamp
Metal Water
Pipe
Meter
670 0194
SERVICE
General
Risk of electric shock. When servicing
pump always disconnect power to electrical outlet
and remove pump electric cord from outlet. Inspect
sump pump and system components monthly. Keep
free of debris and foreign objects.
1. If pump does not operate:
a. Check for loose plug at electric outlet.
b. Check for blown fuses or tripped circuit breakers at
fuse box/circuit breaker box.
c. Be sure nothing interferes with action of float switch.
d. If a, b, and c above check OK, plug in a light that you
know works. If it lights, take your pump to SEARS for
service. If it doesn't light, the electrical circuit is faulty;
consult a licensed electrician.
2. Pump starts, but blows fuses/trips circuit breakers:
After disconnecting power to pump, remove it from
sump. Remove the plate from the bottom of the pump
and make sure that the impeller turns freely. Remove any
debris obstructing impeller. If pump still does not oper-
ate correctly, return it to your nearest SEARS Service
Department for repairs.
3. Pump runs, but does not empty sump:
a. Clean pump intake screen.
b. Water may be entering sump faster than the pump can
discharge it.
c. Be sure vertical distance from pump discharge outlet
to discharge pipe outlet is 18 feet or less.
d. Be sure discharge pipe is not plugged or frozen.
LUBRICATION
Motor has been lubricated at the factory. It does not require
additional oil. Bronze bearing in volute housing is oil im-
pregnated. It does not require additional oil.
5
Advertisement
