Wireless Options - Dell Latitude 3400 Service Manual

Table 14. Power Management (continued)
Option
Enable Advanced
Battery Charge
Configuration
Block Sleep
Wake on LAN/WLAN
Enable USB Wake
Support
Wake on Dell USB-C
Dock
Wireless Radio Control
Intel Speed Shift
Technology
Force Lpm And Aspm
Off

Wireless options

Table 15. Wireless
Option
Wireless Switch
Description
● Adaptive—Default
● Standard - Fully charges your battery at a standard rate.
● ExpressCharge- The battery charges over a shorter period using Dell's fast charging
technology.
● Primarily AC use
● Custom
If Custom Charge is selected, you can also configure Custom Charge Start and Custom Charge
Stop.
NOTE: All charging mode may not be available for all the batteries. To enable this option,
disable the Advanced Battery Charge Configuration option.
This option enables you to maximize the battery health. By enabling this option, your system uses
the standard charging algorithm and other techniques, during the nonwork hours to improve the
battery health.
This option minimizes AC power usage at times of peak demand.
This option allows the computer to power up from the off state when triggered by a special LAN
signal. Wake-up from the Standby state is unaffected by this setting and must be enabled in the
operating system. This feature only works when the computer is connected to AC power supply.
● Disabled—Default - Does not allow the system to power on by special LAN signals when it
receives a wake-up signal from the LAN or wireless LAN.
● LAN Only - Allows the system to be powered on by special LAN signals.
Allows you to enable USB devices to wake the system from standby.
● Enable USB Wake Support
This option is not set by default.
When Wake on Dell USB-C Dock is enabled, connecting a Dell USB-C Dock will wake the
system from Standby.
If enabled, this feature sense the connection of the system to a wired network and subsequently
disable the selected wireless radios.
● Control WLAN radio
● Control WWAN radio
Allows you to enable or disable the Intel Speed Shift Technology.
● Enabled—Default
Force SATA/USB low-power mode and Active State Power Management (ASPM) off in
manufacturing mode.
Description
Allows to set the wireless devices that can be controlled by
the wireless switch.
The options are:
● WLAN
● Bluetooth
System setup 125