Table of Contents
Advertisement
Installing NOx sensor
Note:
Note the following:
• If the sensor (3) was subjected to shock or
impact load, it is considered to be defec-
tive and may not be used.
• Always replace NOx sensor (3) together
with control unit (1).
1.
Screw on control unit (1) at the eyelets and
tighten screws.
2.
Remove protective cap on thread of sen-
sor (3) only just before installation.
Note:
Do not wipe off thread grease of manufactur-
er.
3.
Coat sensor (3) thread with specified assem-
bly compound as required.
4.
Screw in sensor (3) by hand.
5.
Use torque wrench to tighten nut (3) to the specified tightening torque.
Name
Nut
6.
Fit male connector (2) and latch it.
MS150100/06E 2017-08 | Accessories for (Electronic) Engine Governor / Control System | 161
Size
Type
M20
Tightening torque
Lubricant
Value/Standard
(Assembly compound
40 Nm +4 Nm
(Molykote P 37))
Hide quick links:
Advertisement
Table of Contents
