Advertisement
Table of Contents
Optional
q
Recommended
q
Mandatory
3
q
DATE:
MODEL:
REVISION:
SERIAL NO:
SOFTWARE:
REQUIRED TOOLS:
REQUIRED PARTS:
PROCEDURE:
1. Turn off the power to the System Unit.
Disconnect all cables.
2. Place the Micro Lynx System Unit on a
static safe workstation. Ground yourself
and the workstation anti-static mat.
3. Remove the six phillips screws holding
the top cover to the chassis. Remove the
top cover.
4. Remove the two phillips screws securing
the ACG Card to the bracket. Disconnect
the option card cable from the main board
and the M3 Option Card, if installed. Slide
the ACG Card foward until the connectors
clear the back panel and place on a static
safe workstation component side up.
May-10
04/22/92
Micro Lynx
All
All
ACG PROM
Static safe workstation
Grounding wrist strap
Phillips screwdriver
Software Information Sheet
Replacement PROM from TimeLine
PROM Installation Guide
U12
IC Extractor/Insertor or
small slotted screwdriver
Page 1
Micro Lynx ACG Option Card
1755 LA COSTA MEADOWS DRIVE, SUITE B
Figure 1. Remove the Top Cover
TIMELINE VISTA, INC.
SAN MARCOS, CA 92069
TEL. 760-761-4440
(FAX 760-761-4449)
SUPPORT@DIGAUDIO.COM
73J011 REV A
Advertisement
Table of Contents
Related Manuals for TimeLine Micro Lynx ACG Option Card
Summary of Contents for TimeLine Micro Lynx ACG Option Card
- Page 1 PROM Installation Guide Micro Lynx ACG Option Card Optional TIMELINE VISTA, INC. 1755 LA COSTA MEADOWS DRIVE, SUITE B Recommended SAN MARCOS, CA 92069 TEL. 760-761-4440 Mandatory (FAX 760-761-4449) SUPPORT@DIGAUDIO.COM DATE: 04/22/92 MODEL: Micro Lynx REVISION: SERIAL NO: SOFTWARE: ACG PROM...
- Page 2 Figure 2. Removing the ACG Card Page 2 May-10 73J011 REV A...
- Page 3 PROM Installation Guide PROCEDURE continued: 5. Locate U12, the ACG PROM. Remove and replace the PROM. Be careful to correctly align Pin 1 and properly seat the PROM, see Figure 3. Warning Use an IC inserter to remove and replace the PROM. If one is not available, use a small slotted screwdriver.
- Page 4 8. Replace the cover on the System Unit. Insert and tighten the 6 phillips screws. Reconnect the cables and turn on the power. The System Unit will automatically detect the new software version. To verify that the upgraded software is operating, press SYS on the Keyboard Controller, the new software version numbers will be displayed.
Need help?
Do you have a question about the Micro Lynx ACG Option Card and is the answer not in the manual?
Questions and answers