Hitachi CP-X608 Service Manual page 60

When assembling
a. Tighten 9 screws on the bottom and 2 screws on the rear after attaching the upper case with the lamp
door separated.
In order not to make a gap between the upper and the bottom cases, tighten these screws while pressing
down the upper case in the direction of the arrow. Be careful not to bend the outside casing.(Torque:0.39-
0.59N•m)
AUX I/O
SD CARD
DC 5V 0.5A
b. Attach the Front cover.
(1) Attach the Front cover.
(2) Tighten 2 screws on the front.
2 screws
(3) Open the Lens shift cover.
(4) Tighten 2 screws on the upper case.
2 screws
CP-X608(EDX40WL)
front cover
Lens shift cover
60
CAUTION
When re-assembling, tighten these screw at
the torque of 0.49±0.1 N•