Hitachi CP-X608 Service Manual page 20

A
Is PC LAN settings
same as following ?
YES
Is wired
LAN at PC's
network setting disabled?
(Refer Fig.4-1 to 4-2)
YES
Can you connect via
wired LAN ?
YES
Are there any other
PC or something using
wireless LAN?
NO
Is the
wireless LAN
device installed correctly on
your PC?
YES
PWB assembly WIRELESS
CP-X608(EDX40WL)
NO
Change PC LAN settings.
CH:1, SSID:default, ENCRYPTION:off, MODE:
ADHOC, SPEED:AUTO
NOTE: Method of changing the PC LAN setting
depends on your PC. Please read your PC manual.
NO
Disable wired LAN, and confirm
only wireless LAN is enabled.
NO
PWB assembly WIRELESS
Change PC's IP address setting to "192.168.1.N"
(N:1 to 9 or 11 to 254) And check wired LAN
connection when wireless LAN is disabled.
Change the WIRELESS NETWORK
UNIT and your PC's wireless channel
setting differ to other PC or something,
YES
And change SSID except for "wireless".
(When you change SSID, we recommend
to use wired LAN for running "Setting Utility")
(Refer Fig.5)
How to change into wired LAN.
(1) Use MIU SETUP - NETWORK MODE
(2) Remove SD WLAN card, turn off the
power switch, and then turn on the power switch.
Refer your wireless LAN device's
NO
installation manual, and install
wireless LAN device's driver again.
Point to be checked : If you set PC's IP address setting to
"192.168.1.50", input in MS-DOS prompt to "ipconfig" and
response the same IP "192.168.1.50". (Refer Fig.6)
20