Add I/Os - ALLEN & HEATH M-Waves V1 User Manual

Add I/Os

Adding I/O devices not only increases the number of I/O channels, but lets you have separate devices for stage and FOH,
or live room and control room. Use a "star" network configuration with a 1GB Ethernet switch when you need more network
ports than the interface card provides. Only use switches tested and approved by Waves.
You can connect and assign up to 16 SoundGrid I/O devices to the network, depending on the SoundGrid Host
Application. All SoundGrid I/O devices, hosts, and servers are connected through the Ethernet switch. You can also add
more computers to enable streaming among hosts.
A S
DD A ERVER
To add a server to your SoundGrid system, just connect it to the Ethernet switch and configure it in your host application.
This moves all DSP processing from the host computer to the server, which provides a higher plugin count and enables
the eMotion LV1 and ST mixers. Visit the
your SoundGrid host application's user guide to learn about using servers.
6
SoundGrid Host computer
A&H console with SoundGrid I/O
Additional SoundGrid I/O
1GB Ethernet switch
See this
waves.com hardware pages to learn more about SoundGrid servers. Consult
support article for a list of supported switches.
Allen & Heath M-Waves / User Guide