Maintenance and care
•
Maintain the tool with care. A tool in good condition works more reliably, is easier to control and
causes fewer problems.
•
Regularly check the parts of the tool parts. Repair or replace damaged or worn parts. Only use
identical spare parts for maintenance.
•
Follow the instructions for lubricating and replacing accessories.
•
Use only accessories designed for use with this device.
•
Always keep the device clean, dry and free of oil and grease.
•
Maintain the tool labels and nameplates. They contain important information.
Lubrication and storing
If the device is not going to be used for a long period of time, apply a thin layer of lubricant to the steel
parts to prevent rust. Remove the lubricant before using the tool again.
Note! Never use a penetrating oil to lubricate the tool. Penetrating oil can act as a solvent, breaking
down the grease and causing the tool to jam.
Important Note:
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61127
Page 8
05
2021-1