Advertisement
Quick Links
Operating instructions
Drywall Lift
64214
Illustration similar, may vary depending on model
Please read and follow the operating instructions and safety information prior to initial operation.
Technical changes reserved!
Illustrations, functional steps, and technical data may deviate insignificantly due to continuous further
developments.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for WilTec 64214
Summary of Contents for WilTec 64214
- Page 1 Operating instructions Drywall Lift 64214 Illustration similar, may vary depending on model Please read and follow the operating instructions and safety information prior to initial operation. Technical changes reserved! Illustrations, functional steps, and technical data may deviate insignificantly due to continuous further...
- Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating man- ual, nor in the diagrams and illustrations shown.
-
Page 3: Important Instructions
(120 cm or 4-ft) telescoping lift sec- tions • cradle assembly, without its detachable crossarms • two cradle crossarm assemblies © by WilTec Wildanger Technik GmbH Item 64214 Page 3 http://www.wiltec.de 12 2023-1... - Page 4 To mount an arm, pull out the pin with one hand until you can insert the arm with the other hand. 4. Last step Attach two foot plates to the bar so that one person can stand on it (see Fig. 7). © by WilTec Wildanger Technik GmbH Item 64214 Page 4 http://www.wiltec.de...
- Page 5 By turning the handle counterclockwise, the lifter is lowered to the min. height of 1.45 m). • The winches are locked automatically when lifting or lowering the device. © by WilTec Wildanger Technik GmbH Item 64214 Page 5 http://www.wiltec.de...
- Page 6 Always wear a hard hat when Always lift one panel at once! Before releasing the brake, al- operating! ways hold the winch with the right hand. © by WilTec Wildanger Technik GmbH Item 64214 Page 6 http://www.wiltec.de 12 2023-1...
- Page 7 Butterfly nut (M6) Spring pin (3×15) Main support Outer support Hexagon nut (M6) Spindle pulley Hook Shaft pin (12×25) Swivel pulley Spring bolt (5×20) Winch Splint (2.5×30) Non-skid blocks © by WilTec Wildanger Technik GmbH Item 64214 Page 7 http://www.wiltec.de 12 2023-1...
- Page 8 Important note: Reproduction and any commercial use (of parts) of this operating manual, requires a written permis- sion of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 64214 Page 8 http://www.wiltec.de 12 2023-1...
Need help?
Do you have a question about the 64214 and is the answer not in the manual?
Questions and answers