Aqualisa Optic Q WR.BL.CP.20 Installing And Using

Installing your remote control

The remote control can be used to switch your shower on and off without reaching
into the showering area. It's wireless, for a simple installation. Once your shower has
been installed, decide where you would like to position the remote control. It can
operate the shower from up to 10 metres away*. Prior to fitting to the wall, ensure
there is a strong and consistent signal. To test; seat the remote in the mounting
bracket, position in the desired location and operate the remote. To fix to the wall,
peel off the backing paper from the mounting bracket and position it in the desired
location. Press it to the wall for 2 to 3 seconds to ensure it is securely fitted.
* 10m range is dependent on obstacles between the remote and shower controller, building
materials, and the construction of the property. For optimal performance, the controller should be
in direct line of sight with the remote.
Caring for your Registered you
remote control guarantee?
Your remote control should be Register your guarantee instantly.
cleaned using only a soft cloth
aqualisa.co.uk/guarantee
and washing up liquid.
0800 408 4243
Do not use abrasive cleaners.
Need help?
If you need any assistance, you can find some Frequently Asked
Questions at aqualisa.co.uk
Speak to a member of our fully trained Customer Service team on
01959 560010
Alternatively, use Live Chat at aqualisa.co.uk

Declaration of confirmity

Aqualisa Products Limited declares that the wireless rechargable remote and pairing
controllers, in conjunction with the Aqualisa SmartValve , complies with the essential
TM
requirements and other relevant provisions of the Low Voltage Directive (2014/35/
EU), the EMC Directive (2014/30/EU) and the RED Directive (2014/53/EU).
Q4957 Part No 704803 Issue 02 Feb 20
WIRELESS RECHARGEABLE
Remote Control
INSTALLING AND USING YOUR REMOTE CONTROL