Advertisement
VIDEO
5
POSSIBLE PERIMETER WIRE JUNCTION
1
3
5
6
CONNECTING THE PERIMETER WIRE TO THE CHARGING STATION
Before any intervention, disable the master electricity switch
6.1
Unhook the transmitter (T).
6.2
Insert and secure the perimeter wire along the guide in the docking station.
6.3
Cut the excess perimeter wire to about 2 cm above the connectors.
6.4
Connect the input wire to the red terminal of the transmitter (B). Connect the output wire to the black terminal of
the transmitter.
6.5
Secure the docking station to the ground.
6.6
Install the power supply (A) and connect the plug of the power supply unit to the electric outlet.
6.7
Connect the power supply to the power outlet.
6.8
If the transmitter led blinks, the connection is correct.
H. min.
160 cm
(63.00 ")
perimeter wire (M)
ambrogiorobot.com
2
4
6
current power supply unit (A)
protection (L)
transmitter (B)
5.1
If more than one perimeter wire coil is needed, use
the original joint to connect the additional coils.
5.2
Follow the procedure shown in the figure.
connect to
the black terminal
READ THE
MANUAL
transmitter (T)
connect to
the red terminal
Advertisement
