Using The Remote Control - DirecTV HIRD-E6 Owner's Manual

VCR CODE NUMBER
Salora 014
Samsung 102 040 032 104 107 109
112 113 115 120 122 125
159
Sansui 043 048 135 022
Sanyo 003 010 102 007 014 134
Scott 017 037 044 129 131 112
159
Sears 003 008 009 010 013 014
017 081 101
Sharp 031 054 053
Shintom 024
Signature 034
Sony 056 057 058 003 052 149

Using the Remote Control

Once your codes are entered, you are ready to start using your universal remote control. The device
keys allow you to switch from one device to another. Some keys behave in a special way. They control
one device while you are actually in another device mode. For instance, while in SATellite mode,
pressing Volume +/- controls your TV's volume—not a digital satellite receiver volume. This is
because the remote control knows that there is no volume control on the digital satellite receiver.
Advanced feature keys (i.e.
satellite receiver. For other devices, only the primary keys (i.e.
For Sony-brand devices, use the
For RCA-brand devices, the device key (i.e., "TV" or "VCR") might be the "power on" key and
is the power off key.
Switching the Remote Control to Operate Additional
Digital Satellite Receiver
Your remote control can be reprogrammed to operate additional digital satellite receivers. This may be
necessary in situations where multiple digital satellite receivers are located in the same general area
and can pick up signals intended for each other.
To switch the remote control, simply press and hold the
The receiver ID can be 001 through 008. Do not forget the two zeros. Remember to access the
ADVANCED PREFERENCES screen using the keys on the front of the digital satellite receiver to
pair it with the remote control.
The other way to program your remote control to match you digital satellite receiver is to scan for the
correct code.
1. Keep your remote control aimed at the device you want to control during this process. The
remote control will send out the "power" command for the digital satellite receiver.
2. While holding down the SAT key, press the "Mute" key for one full second. Then release the
keys. The SAT key should light and stay lit. If it doesn't, repeat the process.
3. Once you are in programming mode, repeatedly tap the
sending out the power command. This could take up to eight presses. When your digital
satellite receiver shuts off, you have found the code.
4. Press the
press the SAT key again.
The remote will remember the code until you reprogram it.
PROGRAMMING YOUR REMOTE CONTROL
VCR CODE NUMBER
031 155
Soundesign 034
STS 013
Sylvania 031 059 034 067
Symphonic 034
Tandy 010 034
Tatung 039 043 023
Teac 034 039 043 023
Technics 031 070
Teknika 031 019 034 101
TMK 006
Toshiba 112 008 131 047 059 082
013 042
Totevision 040 101
, ) are not supported for devices other than your digital
key to verify that you haven't missed the code. In order to lock in the code,
VCR
Unitech
Vector
Research
Video Concepts
Videosonic
Wards
Yamaha
Zenith
and
key as the "Enter" key.
key while entering the receiver ID.
key to step through the codes,
CODE NUMBER
040
012
012 046 034 141
040
003 013 024 031 034 040
053 054 017 131
012 043 034 039
072 080 056 048 034 101
058
, ) will function.
P 8-3
AGE