Transport And Handling - Trane CXPA Installation Operation & Maintenance

Fig. 01 - Transport and Handling Instructions.
! WARNING!
The lifting equipment capacity
must exceed the unit weight by a
proper safety factor in order to
avoid death or equipment damage.
! WARNING!
Each of the cables, chains or slings
used to lift the unit must be capable
of supporting the entire weight of
the unit.
SSC-SVN001F-EN
Transport and
Handling
TRANSPORT
Upper wooden
base
Lower wooden
base
WITHOUT BOX
Handling
Instructions
Proceed as follows to transport and
handle the unit:
1. Check the manual or nameplate for
the actual equipment weight.
2. For all units, place lifting cables or
chains under the skid.
methods may cause serious injuries or
equipment damage.
3. Do not allow chains, slings or steel
cables to touch the AC unit in order to
avoid damages or accidents. Use
suitable spreader bars as shown in the
figure.
WITH BOX
and Displacement
Other lifting
Lifting sling
Spreader
bar
W ooden
box
Lower wooden
base
4. The module packaging material
should only be removed after the unit is
placed at the final mounting location.
Take proper care while handling the
equipment.
5. During transportation, do not swing
the unit more than 15º (fifteen grades)
in relation to the vertical position.
6. Always test-lift the unit to ensure
proper balance and stability before
lifting the unit to the mounting location.
7. For horizontal displacement, use
rollers of equal diameter under the
wooden base.
7