Dell U4919DWB Simplified Service Manual page 15

7
8
Attach the stand assembly
to the monitor
1. Fit the two tabs on the
upper part of the stand
to the groove on the
back of the monitor
2. Use a Phillips
crosshead screwdriver
to attach the four
screws to secure the
stand assembly to the
monitor
Attach the VESA cover to
the monitor
1. Insert the cover with
the lower part
downward. Do NOT
attach the latch at
this point
2. Tilt to fit the three tabs
on the upper part of
the cover to the groove
of the back of the
monitor
3. Press the cover down
till the latch snaps into
place
- 15 -
NOTE: When
attaching the
stand
assembly, tilt
the stand
base
upwards and
make sure
that the stand
base does
not hit the
surface