Eachine Novice-IV 3-4S 4inch LR drone RTF Manual

1. Install antenna mount and Battery anti-slip mat
Screw the antenna fixing mount and put the antenna sleeve into the fixing mount.
Then use some hot melt glue to fix the antenna sleeve.
2
1
2 Specification .
Brand Name: Eachine
Item Name: Novice-IV 3-4S 4inch LR drone RTF
Wheelbase: 170mm
Size: 180mm*130mm*40mm(without propellers,batteries,antenna)
Weight: 125g (without battery)
3 Features .
The lightest 4inch LR FPV drone
New AIO Flight controller with 25A ESC
Efficiency 1404 KV2750 brushless motor
Long flight time around 20minutes with stock battery Sub 250gram
Around 31minutes flight time with 4s 18650 3000mah
Very stable and easy to control
With M8N GPS Rescue system
With Buzzer and LED drone tracker finder
Distance Range more than 1KM in an Open area without interference
131
188
4. Advanced function description
1. DT-B90 Finder can power itself to beep and LED light to flash even the quad
battery has been ejected.
2. Press the button for 2 or 3 seconds to turn on it before flying
3. You can use AUX4(SF Switch) channel to activate the Buzzer
4. You need to Press the button for 2 or 3 seconds to turn off it after disconnect
the main battery.
1. Before Armed, GPS must search for more than 6 satellites to lock the home
position.
2. After armed, observe the OSD data during the flight, and the rescue function
can work normally only if the distance exceeds 100 meters. Otherwise, the quad
will crash. If the remote controller suddenly loses signal, the GPS rescue
function will work automatically and return to the home position, but the drone
won't land automatically. You need to slightly control the stick to gain control of
the drone when the remote control signal is restored and then control the drone
to land.
3. In order to avoid mistake operation , we didn't enable Aux Channel to activate
the GPS rescue function by default. You can set it by yourself from the mode tab
of Betaflight configurator.
3
Position need to use hot
1 2 3
melt glue to fixed
146
5 Start FPV Flight .
Install the antenna to the radio and the goggle first. And then powering on your
Radio and goggle. NOVICE-IV comes already bound to your radio and on the
right video channel matched with your goggles. Power the battery is plugged in,
set NOVICE-IV on a stable surface so it can calibrate.Calibration takes a few
seconds then NOVICE-IV is ready to fly. Please fly in open areas and away from
the crowd and buildings.
A
1
B
1 Install the battery to the radio(shows on picture A), and turn on the "power .
switch", Press any key to skip if any alarm(show on the Picture B) appear on the
screen
2
2 Connect the battery to the NOVICE-IV Drone, and make sure to fixed the .
battery properly with the Lipo strap.
3
GPS
3 Turn on the EV800DM Goggles, check the video and the status of the oSD info ， .
Make sure GPS must search for more than 6 satellites to lock the home position .
4
4 Keep the throttle stick lowest point and then toggle the SE Switch to Arm the .
NOVICE-IV drone , you will find "ARMED" notice on the screen of the goggles.
Happy flight and keep it safe .