Advertisement
NOTE: The M510 supports Micro-SIM sized SIM cards only.
The orientation of the SIM cards is different, be sure to
insert the SIM cards correctly. Inserting the SIM cards
incorrectly will result in the inability to use the LTE
functionality.
NOTE: If the SIM card is inserted or replaced after bootup,
a reboot is required.
Unleashed Network Configuration
Setup Using the Unleashed Mobile App
To perform setup using the Unleashed Mobile App, download the
iOS or Android app from the app store.
1. As soon as the Unleashed AP is powered on and connected
to the local network, it boots up and begins broadcasting a
temporary unencrypted WLAN named "Configure.Me-
[xxxxxx]" from both radios.
2. Using your client's Wi-Fi connection settings, select and
associate to the "Configure.Me-[xxxxxx]" WLAN.
3. Launch the app, and follow the on-screen instructions to
configure your Unleashed network(s).
FIGURE 4 Unleashed Mobile App for iOS and Android
Copyright
©
2018 ARRIS Enterprises LLC. All rights reserved.
Published December 2018, Part Number 800-71989-001 Rev A
FIGURE 5 Configuring Unleashed from the Mobile App
Setup Using a Web Browser
1. As soon as the Unleashed AP is powered on and connected
to the local network, it boots up and begins broadcasting a
temporary unencrypted WLAN named "Configure.Me-
[xxxxxx]" from both radios.
2. Using your client's Wi-Fi connection settings, select and
associate to the "Configure.Me-[xxxxxx]" WLAN.
3. Launch a web browser and enter the following into the
browser's URL bar: unleashed.ruckuswireless.com, and press
Enter.
4. You will be redirected to the Setup Wizard. Complete the
steps in the Setup Wizard and click Finish.
FIGURE 6 Complete the Setup Wizard to set up your
Unleashed network
5. Once the Setup Wizard is finished, a "Configuring system
settings and rebooting" progress screen appears. Wait until
the process is complete.
6. Connect to the WLAN that you configured in the Setup
Wizard, and click OK to reconnect. You will be redirected to
the Unleashed login screen.
7. Enter your Admin Name and Password to login.
FIGURE 7 The Login page
8. Upon successful login you will be presented with the
Unleashed Dashboard, which displays an overview of your
Ruckus Unleashed network.
Mounting Instructions
Mounting on a Flat Surface
1. Use the Mounting Template on the last page of this Quick
Setup Guide as a template to mark the locations for drill
holes on the mounting surface.
2. Use a 5mm drill bit to drill holes approximately 25mm into
the mounting surface.
3. Insert the anchors and mounting screws into the mounting
surface, leaving approximately 1/4" (6 mm) of the screw
heads protruding for the AP enclosure.
4. To remove the AP, insert the unit removal pin into the hole
on the top of the AP to unlock, then push the AP up to
release the AP enclosure from the mounting screws.
FIGURE 8 Flat surface mounting
Page 2 of 4
Advertisement
