Maintenance And Care - Black & Decker Prise Pfister KENZO RT6 Series Manual

14 UNIT START UP
Turn on hot and cold water supply valves.
CAUTION: Check all connections for leaks. Failure to do so can result in
water damage.
15
15A
15 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may have
collected in the water lines, it is necessary to flush the system. Open Valves (15A)
to full on position and activate Diverter Valve by lifting Knob (15B) allowing water
to flow from the Spray Hose (15C). Run water for one minute. Repeat in hot and
cold positions.
16
16 HAND HELD SHOWER INSTALLATION
Insert Washer (16A) into Metal Hose Fitting (16B) located on the end of Decorative
Hose (16C). Connect Hand Held Shower (16D) into the end of Decorative Hose (16C)
by turning Metal Hose Fitting (16B) clockwise. Hand tighten.
15B
15A
15C
16D
16A
16B
16C
ENGLISH
17
15
3 / "
32
(88 mm)
17 AIR GAP
Air Gap for this spout is as shown. Please consult your local building code for Air Gap
restrictions.
MAINTENANCE & CARE
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price
Pfister Consumer Service.
Always turn off water and relieve pressure before working on your
3.
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain porcelain or other similar substance
are not acceptable for public areas or commercial use. Installation
of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
5