Lubricating The Machine; Electromagnetic Brake - Clarke SA40 20D Instructions For Use - Original Instructions

LUBRICATING THE MACHINE

Apply grease to (or grease fi tting locations) (AA):
Use grease type Lubriplate 730-2 or equivalent
®
• Steering Chain
• Drive Wheel Chain
• Drive Chain Idler Sprocket (grease fi tting)
• Steering Shaft (steering assembly tube)
Once a month, apply light machine oil to lubricate the (AB):
• Steering shaft universal joints

ELECTROMAGNETIC BRAKE

See Figure 8. The drive wheel motor has a built in
electromagnetic brake that is engaged whenever the Key
Switch (A) is OFF or the Go Pedal (18) is not being pressed,
machine in neutral. This brake can be manually overridden if
necessary by reaching up around the back of the front drive
wheel and rotating the Brake Arm (AC) up as shown. This
should only be done in the event you need to push or pull the
unit. Remember to re-engage the brake arm once you fi nish
moving the machine. NOTE: Turn the drive wheel 45° to the
right for easier access to the brake arm.
1/2016
INSTRUCTIONS FOR USE
AA
AA
AB
AB
AA
AA
FIGURE 8
AC
56091196 - SA40
ENGLISH - A
FIGURE 7
A - 17