Related Manuals for Vectaire EVO220DC
Summary of Contents for Vectaire EVO220DC
- Page 1 EVO220DC Whole House Heat Recovery Unit with Low Energy DC Motor and LCD control for domestic and commercial use Installation, Operating and Maintenance Instructions...
- Page 2 Vectaire will not be held responsible and will not accept liability for any damage caused to persons or property through failure to follow the guidance provided in this manual. It should always be available with the product for easy reference.
- Page 3 Page 3 IT IS IMPORTANT THESE THESE INSTRUCTIONS ARE READ FULLY Dimensions BEFORE INSTALLATION • This product should not be used for any purpose other than that for which it was designed and as shown in this leaflet. • All packaging should be removed and the unit checked for damage in transit.
- Page 4 Page 4 Duct and Duct Connections (refer to design drawing) • 4 x 125mm spigots are provided for the connection of ducting. These are clearly marked for correct connection of the supply and exhaust ducts. • Where ducting is installed in an unheated space, all of the ducts should be insulated. Where ducting is in stalled in a heated space, only the cold ducts should be insulated.
- Page 5 Before carrying out any maintenance or cleaning operations the mains electrical supply MUST be disconnected. The air filters and heat exchanger of the Vectaire EVO220 should be cleaned regularly by a suitably qualified person (the frequency of cleaning will vary depending on the installation environment). Filters should be replaced after a maximum of 3 cleaning cycles.
Need help?
Do you have a question about the EVO220DC and is the answer not in the manual?
Questions and answers