Whole house heat recovery unit with low energy dc motor and lcd control for domestic and commercial use (5 pages)
Summary of Contents for Vectaire WHHR100/60DC
Page 1
"WHHR100/60DC" Whole House Heat Recovery Unit with Low Energy DC Motor - for domestic and commercial use Installation, Operating and Maintenance Instructions...
Page 2
Vectaire will not be held responsible and will not accept liability for any damage caused to persons or property through failure to follow the guidance provided in this manual. It should always be available with the product for easy reference.
Page 3
WHHR100/60DC Installation IT IS IMPORTANT THESE THESE INSTRUCTIONS ARE READ FULLY BEFORE INSTALLATION • This product should not be used for any purpose other than that for which it was designed and as shown in this leaflet. • All packaging should be removed and the unit checked for damage in transit. If there is any damage, please contact your supplier •...
Page 4
Duct and Duct Connections (refer to design drawing) • 4 x 125mm nominal diameter spigots are provided for the connection of ducting. These are clearly marked for correct connection of the supply and exhaust ducts. Flexible duct fits over the spigots, whilst rigid duct fits into the spigots.
Page 5
• Before carrying out any maintenance or cleaning operations the mains electrical supply MUST be dis- connected. The air filters and heat exchanger of the Vectaire WHHR100/60DC should be cleaned regularly by a suitably qualified person (the frequency of cleaning will vary depending on the installation environment). Filters should be replaced after a maximum of 3 cleaning cycles.
Page 6
Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, Buckinghamshire, HP12 3RH Tel: +44 (0)1494 522333. Fax: +44 (0)1494 522337. Email: sales@vectaire.co.uk E & O.E WHHR100/60DCJuly2012...
Need help?
Do you have a question about the WHHR100/60DC and is the answer not in the manual?
Questions and answers