Table of Contents
Advertisement
8 February 2021
CRUISE CONTROL WIRING 2000-2002 6-speed MANUAL ONLY
This step is only for 2000-2002 manual transmission trucks with cruise control. All
other vehicles do not need the cruise control wires connected as they use a vacuum
servo for cruise control rather than an internal program in the ECM.
If your vehicle does not have cruise control you can remove the blue and green wires
from the DFIV and discard them. Skip this step and proceed to Switch Installation.
To obtain access to the Cruise
Control wiring harness remove the
lower steering column panel by
removing the mounting screws
and unsnapping the panel from the
instrument panel.
Under the dash running vertical by
the left of the steering column,
locate the smaller wiring harness
that runs out of the main harness.
Remove some of the black electrical tape to gain access to the smaller wire bundle.
THERE IS A BLACK WIRE WITH A TWISTED LIGHT BLUE/GREEN TRACER DO
NOT CONNECT OR TEST THIS WIRE AS IT IS CONNECTED TO THE AIR BAG
AND THE BAG MAY DEPLOY CAUSING DAMAGE AND/OR INJURY
Remove some of the black electrical tape from the small bundle to gain access to the
small Black wire with Light Blue tracer and install a Posi-Tap™ to it. Insert the Blue
wire from the DFIV module into this connector.
In this same wiring harness, locate the Red wire with Light Green tracer and install
another Posi-Tap™. Insert the Green wire from the DFIV module into this connector.
BD Universal Remote Mount Vacuum Brake
***DANGER***
***DANGER***
BD Engine Brake Inc.
1-800-887-5030 | https://www.bddiesel.com
12
Advertisement
Table of Contents
