Table of Contents
Advertisement
Person responsible
for the product
1.5
Exposure to Radio
Frequency (RF) Sig-
nals
☞
Safety Directions
The person responsible for the product has the following duties:
To understand the safety instructions on the product and the instructions
•
in the User Manual.
To ensure that it is used in accordance with the instructions.
•
To be familiar with local regulations relating to safety and accident pre-
•
vention.
To inform Leica Geosystems immediately if the product and the applica-
•
tion becomes unsafe.
To ensure that the national laws, regulations and conditions for the oper-
•
ation of the product are respected.
Hazards of Use
The product is normally operated at least 1 m away from the user. At a dis-
tance of at least 1 m or greater, the typical power density level is below
2
2
1 mW/cm
(0.01 W/m
). This value is far below the level specified by the cur-
rent regulations.
When operated in the normal manner of intended use, this product
☞
does not pose health or safety risks regarding radio frequency sig-
nals.
To ensure that the radio modem is not operated without the permission of
the local authorities on frequencies and/or output power levels other than
those specifically reserved and intended for use without a specific permit, the
internal and external radio modems have been designed to operate on fre-
quency ranges and output power ranges. The exact use of the frequency
ranges differs from one region and/or country to another.
NOTICE
Dropping, misusing, modifying, storing the product for long periods or
transporting the product
Watch out for erroneous measurement results.
Precautions:
▶
Periodically carry out test measurements and perform the field adjust-
ments indicated in the User Manual, particularly after the product has
been subjected to abnormal use as well as before and after important
measurements.
7
Advertisement
Table of Contents
