Devolo MicroLink dLAN ADSL Modem User Manual page 22

22
Router configuration
b
The router can always perform only one function, i.e. either as a server or
relay.
Please note that disabling the DHCP server will disable the setup wizard. The
setup wizard can only be used if the MicroLink dLAN ADSL Modem Router is
set up as the DHCP server for the LAN.
WAN
Wide-area network settings can be defined under 'WAN'. The configuration
corresponds to your Internet access settings.
If you set up your Internet access using the setup wizard, and only plan to exe-
cute standard applications with the MicroLink dLAN ADSL Modem Router,
the entries on this screen do not need to be modified manually. Most of the
functions listed here, which are optimally and automatically configured by
|
devolo MicroLink dLAN ADSL Modem Router
|
'DHCP address pool selection': Select 'System Allocated' to automa-
tically assign an IP address from your IP address pool; select 'User
Defined' to assign an IP address manually.
'User Defined Start Address': When working with a user-defined
DHCP address pool, enter the IP start address manually.
'User Defined End Address': When working with a user-defined DHCP
address pool, enter the IP end address manually.
'DHCP Relay': If this function is enabled, the router will serve as a relay
and forward DHCP queries to the DHCP server.
'DHCP Relay Target IP': Enter the IP address of the DHCP server here
if the router is to be used as a relay.
|