J.Burrows Matrix JBMATEL12K User's Manual And Troubleshooting Manual

User Manual and Trouble Shooting Guide
Matrix Executive Electric Height Adjustable Desk
1. nitial Setup I
Learning Process:
A.
Press and
Stroke Reset
B.
After the initial assembly of the desk or if the display shows either of "E10, E20
press the
move down to the lowest point and rebound back up. The learning process & stroke reset
is then finished and will display the lowest height position.
2. Lifting
The desk will go up and down when pressing
3. Height memory setting
Move the desk up or down to a desired position. Press the
display will blink, then press a numeric key (
to the corresponding preset position. The display will stop blinking and exit the memory
mode if there is no numeric key pressed within 5 seconds.
Once you have saved the desired heights you can press that numeric key to automatically
move the desk to the saved height.
4. Setup Menu
1. Press and hold the
2. Press the
is as follows:
 Unit（
 Brightness（
JBMATEL12K, JBMATEL15K, JBMAEV15OA
button for 3 seconds after the initial assembly of thedesk.
button for 3 seconds or until it shows
button for 3 seconds, display will show "S--" and blink.
button to move through the below setup menu functions, the function list
）: Display height on screen in centimeters or inches;
）: Brightness of the controller;
or .
, ,
or
1/3
or
, the desk will automatically
button after which the
) to save the desired height
E60",