Table of Contents
Advertisement
Power Cords
The power cord set included in the system meets the requirements for use in the country
where the system was purchased. If this system is to be used in another country, contact
your sales representative to purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on
the product's electrical ratings label. The voltage and current rating of the cord should be
greater than the voltage and current rating marked on the product. In addition, the cross-
sectional area of the wires must be a minimum of 1.00mm² or 18AWG, and the length of
the cords must be between 1.8m (6 feet) and 3.6m (12 feet). If you have questions about
the type of power cord to use, contact your sales representative.
The following statement applies only to rack-installed products that are GS-Marked:
This equipment is not intended for use at workplaces with visual display units, in
accordance with §2 of the German ordinance for workplaces with visual display units."
11
Advertisement
Table of Contents
