Table of Contents
Advertisement
Canadian Notice (Avis Canadien)
Class A Equipment
Power Cords
The power cord set included in the system meets the requirements for use in the country where the system
was purchased. If this system is to be used in another country, contact your sales representative to
purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. In addition, the cross-sectional area of the wires must be a minimum
of 1.00mm² or 18AWG, and the length of the cords must be between 1.8m (6 feet) and 3.6m (12 feet). If you
have questions about the type of power cord to use, contact your sales representative.
The following statement applies only to rack-installed products that are GS-Marked:
This equipment is not intended for use at workplaces with visual display units, in accordance
with §2 of the German ordinance for workplaces with visual display units."
8
Advertisement
Table of Contents
