Uberhaus 1362 Manual page 4

Heating 2/BOOST function (1500W, maximum power level):
The appliance operates at the maximum power for rapid heating of the room.
6.4. ECO function ： In this operating mode you can set the desired temperature by pressing the
+ and - adjustment buttons (B). The appliance will automatically set the power level to guarantee
the best comfort while reducing energy consumption. In this operating mode the unit may switch
the heating power level from maximum to minimum and vice-versa, several times in an hour.
When using the ECO function, the maximum temperature setting is (32°C/90°F).
7. To turn off the appliance press button ON /OFF (A). The display will show a countdown for about 6
seconds. Then, remove plug from power outlet.
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
Delayed switch-on: with the appliance in the OFF position, press the timer button (D) (
The display shows the symbol
To set the timer, use the + and - adjustment buttons (B), then wait a few seconds for the
programming to be set. The display shows the symbol to indicate you have set the timer. When
the programmed time has been reached, the appliance turns on with the same settings it had
during the previous operation.
Delayed shut-off: with the appliance on, press the timer button (D) (
the symbol (
To set the timer, use the + and – adjustment buttons (B), then wait a few seconds for the
programming to be set. The display returns to show the current settings and the symbol to
indicate you have set the timer. When the programmed time has been reached the appliance
shuts off automatically.
If you want to go back to operation without the timer, press the timer button (D) twice. The timer
symbol disappears from the display.
THERMOSTAT INSTRUCTIONS
1. Press the MODE button (E) until the Mode indicator lights in ECO mode.
2. To adjust set temperature, Press the button + to increase the desired temperature and the button -
to decrease the desired temperature.
3. When the air temperature reaches 2 degrees above the set temperature, the heater will stop to
heat at once and stop to blow after 15 seconds.
4. When the air temperature drops 2 degree below the set temperature, the unit will come back on.
NOTE:
The display can show the temperature in both °F and °C. To change the temperature scale, press and
hold the ºC/ºF key.
Please be aware that as this display is for information purposes only and not a precision device. The
displayed temperature may slightly vary from the actual temperature.
It is normal for the heater to cycle ON and OFF as it maintains the set temperature.
When adjusting temperature, the set temperature on display will flicker for 5 seconds. In 5 seconds, if
no changes are made, LED lights will stop flickering, display room temperature again.
USING THE REMOTE CONTROL
The remote control functions are identical to those on the control panel. See the section "Operation"
on the previous page for a description of the functions.
INSERTING OR REPLACING BATTERIES
- Remove the cover on the rear of the remote control;
- Insert the button battery (model CR/2032/3V) into remote control with the positive pole (smooth
side) facing up.
) and the time remaining before shut-off.
and the time remaining before switch-on.
4
).
). The display shows