Operation And Use - Uberhaus 1362 Manual

9. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it
may cause an electric shock or fire or damage the heater. Do not block or tamper with the heater
in any manner while it is in operation.
10. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place heater
on soft surfaces, like a bed, where openings may become blocked.
11. Always place the heater on a stable, flat, level surface when operating, to avoid the chance of the
heater overturning. Locate the power cord so the heater or other objects are not resting on it. Do
not run power cord under carpeting. Do not cover power cord with throw rugs, runners, or the like.
Arrange power cord away from room traffic and where it will not be tripped over.
12. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use
handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and keep them at
least 1 foot (0.3m) from the sides and rear.
13. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
14. A heater has hot and arcing or sparking parts inside. It must NOT be used in potentially dangerous
locations such as flammable, explosive, chemical-laden or wet atmosphere. This heater is
intended for use in general use only.
15. This heater is not intended for use in wet or damp locations. Never locate a heater where it may
fall into a bathtub or other water container.
16. Do not use this heater outdoors.
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS HEATER
WITH ANY SOLID STATE SPEED CONTROL DEVICES.

Operation and Use

The heater may be operated by the manual controls located on the heater. The heater working state
may be known from display panel (as shown in Figure 1)
Carefully remove the heater from its bag and carton.
1.
The heater must be placed on a firm, level surface.
2.
Plug the cord set into a 120V～ electrical outlet. Be sure plug fits tightly in outlet. A loose fit will
3.
cause overheating and damage the plug. Plug and cord set may feel warm during normal usage.
When the heater is initially plugged in, there will be a "beep" and the red light (G) will come on
4.
indicating that there is power to the unit. The red light will remain lit until the heater is unplugged
from the electrical outlet.
Press the ON/OFF button (A) to turn on the appliance. It will begin to heat with the predefined
5.
settings. The LED on unit will display the current room temperature.
Press the MODE button (E) to select one of the following functions available: Heating 1 （
6.
Heating 2 （
6.1 Ventilation (
the room.
6.2 Anti-freeze (
45°F (7°C) to prevent freezing temperatures.
6.3 Heating 1 and Heating 2
Heating 1 (900W, minimum power level):
The appliance operates at the minimum power, reducing noise and energy consumption to the
minimum.
SAVE THESE INSTRUCTIONS
）
ECO
) In this operating mode only the fan operates, so the appliance does not heat
)In this operating mode the appliance keeps the room at a temperature of
Ventilation( ) Anti-freeze (
3
）
).